HTML Code here
USE 2 x 12’s or 2 x 4’s to make them cheap. detailed instruction, and actual use. these will not slide as wood will grip better than plastics or metals ans prevent slipping.
Likes: 92
Views: 9352
USE 2 x 12’s or 2 x 4’s to make them cheap. detailed instruction, and actual use. these will not slide as wood will grip better than plastics or metals ans prevent slipping.
Likes: 92
Views: 9352
Comments are closed.
Really good video mate thank you
Hi mate what screw size did u use ? An the second ramp you show at the end, made with smaller blocks of wood, is it screwd togeather ?
Thank you for reply. On your 10.5 ramp, are boards 10" wide an 1.5 thick ? An what size screw would i need ? Sorry im new to wood work ? An thanks agaun for your help
Thank you for your reply. I brought a 10' wide an 5 ' high today. I hot a normal saw so trying tcut through it to make 2 halfes for each tyer. Then i gota try plain in down from 1 end. It was £25 just for the 1 wood, quite expensive thank you again
Thanks 🙂
Garbage. Don’t follow this idiots example.
very helpful, thank you very much! I'll be building mine this weekend
Good job. I HATE sliding steel ramps too. I saw a guy's ramps with casters on the ends for rolling around when not in use.
Please subscribe by using the following link:
http://www.youtube.com/mrdidrill?sub_confirmation=1